Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JackBruno

Pages: [1]
1
Hacking and Security / Re: airmon-ng issue still not resolve damn! broadcom sucks!
« on: September 15, 2014, 11:08:31 am »
lspci -knn
Code: [Select]
00:00.0 Host bridge [0600]: Intel Corporation Atom Processor D4xx/D5xx/N4xx/N5xx DMI Bridge [8086:a010]
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: agpgart-intel
00:02.0 VGA compatible controller [0300]: Intel Corporation Atom Processor D4xx/D5xx/N4xx/N5xx Integrated Graphics Controller [8086:a011]
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: i915
Kernel modules: i915
00:02.1 Display controller [0380]: Intel Corporation Atom Processor D4xx/D5xx/N4xx/N5xx Integrated Graphics Controller [8086:a012]
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
00:1b.0 Audio device [0403]: Intel Corporation NM10/ICH7 Family High Definition Audio Controller [8086:27d8] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: snd_hda_intel
Kernel modules: snd-hda-intel
00:1c.0 PCI bridge [0604]: Intel Corporation NM10/ICH7 Family PCI Express Port 1 [8086:27d0] (rev 02)
Kernel driver in use: pcieport
Kernel modules: shpchp
00:1c.1 PCI bridge [0604]: Intel Corporation NM10/ICH7 Family PCI Express Port 2 [8086:27d2] (rev 02)
Kernel driver in use: pcieport
Kernel modules: shpchp
00:1c.2 PCI bridge [0604]: Intel Corporation NM10/ICH7 Family PCI Express Port 3 [8086:27d4] (rev 02)
Kernel driver in use: pcieport
Kernel modules: shpchp
00:1c.3 PCI bridge [0604]: Intel Corporation NM10/ICH7 Family PCI Express Port 4 [8086:27d6] (rev 02)
Kernel driver in use: pcieport
Kernel modules: shpchp
00:1d.0 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB UHCI Controller #1 [8086:27c8] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: uhci_hcd
00:1d.1 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB UHCI Controller #2 [8086:27c9] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: uhci_hcd
00:1d.2 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB UHCI Controller #3 [8086:27ca] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: uhci_hcd
00:1d.3 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB UHCI Controller #4 [8086:27cb] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: uhci_hcd
00:1d.7 USB controller [0c03]: Intel Corporation NM10/ICH7 Family USB2 EHCI Controller [8086:27cc] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: ehci-pci
00:1e.0 PCI bridge [0604]: Intel Corporation 82801 Mobile PCI Bridge [8086:2448] (rev e2)
00:1f.0 ISA bridge [0601]: Intel Corporation NM10 Family LPC Controller [8086:27bc] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: lpc_ich
Kernel modules: lpc_ich
00:1f.2 SATA controller [0106]: Intel Corporation NM10/ICH7 Family SATA Controller [AHCI mode] [8086:27c1] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: ahci
Kernel modules: ahci
00:1f.3 SMBus [0c05]: Intel Corporation NM10/ICH7 Family SMBus Controller [8086:27da] (rev 02)
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel modules: i2c-i801
05:00.0 Network controller [0280]: Broadcom Corporation BCM4313 802.11bgn Wireless Network Adapter [14e4:4727] (rev 01)
Subsystem: Wistron NeWeb Corp. Device [185f:051a]
Kernel driver in use: wl
Kernel modules: wl, bcma
09:00.0 Ethernet controller [0200]: Marvell Technology Group Ltd. 88E8040 PCI-E Fast Ethernet Controller [11ab:4354]
Subsystem: Samsung Electronics Co Ltd Notebook N150P [144d:c072]
Kernel driver in use: sky2
Kernel modules: sky2

....

EDIT: just leave your reply be back tomorrow!

Staff note: please do not double post.. use the modify button instead

2
Hacking and Security / Re: airmon-ng issue still not resolve damn! broadcom sucks!
« on: September 15, 2014, 10:51:30 am »
Yes it cause an error i tried this before...
Code: [Select]
Error for wireless request "Set Mode" (8B06) :
    SET failed on device eth1 ; Operation not supported.

3
Hacking and Security / airmon-ng issue still not resolve damn! broadcom sucks!
« on: September 15, 2014, 10:41:23 am »
hola amigos! my problem still annoying me!
Code: [Select]
Interface    Chipset        Driver

eth1        Broadcom    wl - [phy0]mon0: ERROR while getting interface flags: No such device

                (monitor mode enabled on mon0)

WHAT I DID!
*apt-get install b43-fwcutter firmware-b43-installer (DID NOTHING!)
*modprobe -r b44 b43 b43legacy and modprobe wl (DID NOTHING!)
*reinstall aircrack (SAME!)

now if theres a command! i need to type like lspci, etc... etc... just reply it
thanks in advance!

4
Hacking and Security / Re: Airmon-ng goes weird!
« on: September 02, 2014, 01:57:18 pm »
Code: [Select]
airmon-ng check kill
...
...
...
killing all those process
...
Code: [Select]
dmesg | grep eth1
....
[same as above]

5
Hacking and Security / Re: Airmon-ng goes weird!
« on: September 02, 2014, 01:03:56 pm »
Okay i run ...
Code: [Select]
dmesg | grep eth1

[   19.894588] eth1: Broadcom BCM4727 802.11 Hybrid Wireless Controller 6.20.155.1 (r326264)
[  233.870793] ERROR @wl_notify_scan_status : eth1 Scan_results error (-22)
i tried to remove my interface from wicd and run it... same!

6
Hacking and Security / Re: Airmon-ng goes weird!
« on: September 02, 2014, 12:51:48 pm »
okay... i already did this but. here it is
Code: [Select]
airmon-ng check eth1

PID Name
1019 avahi-daemon
1020 avahi-daemon
3464 wpa_supplicant
3487 dhclient
Process with PID 3464 (wpa_supplicant) is running on interface eth1
Process with PID 3487 (dhclient) is running on interface eth1
and what do you mean about dmesg command? do i need to copy that crap and paste it here? thats kinda
longer

7
Hacking and Security / Re: Airmon-ng goes weird!
« on: September 02, 2014, 12:00:16 pm »
lol.. that is the first thing that i do! when i got this error...

8
Hacking and Security / Re: Airmon-ng goes weird!
« on: September 02, 2014, 11:36:26 am »
Okay as you wish.
Code: [Select]
ifconfig -a
eth0      Link encap:Ethernet  HWaddr e8:11:32:2e:a6:fd 
          UP BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
          Interrupt:18

eth1      Link encap:Ethernet  HWaddr 00:1b:b1:a9:ac:e0 
          inet addr:192.168.1.124  Bcast:192.168.1.255  Mask:255.255.255.0
          inet6 addr: fe80::21b:b1ff:fea9:ace0/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:25357 errors:8 dropped:0 overruns:0 frame:34474
          TX packets:29140 errors:34 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:17317109 (17.3 MB)  TX bytes:4038775 (4.0 MB)
          Interrupt:16

lo        Link encap:Local Loopback 
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:65536  Metric:1
          RX packets:43 errors:0 dropped:0 overruns:0 frame:0
          TX packets:43 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:7460 (7.4 KB)  TX bytes:7460 (7.4 KB)
and then...
Code: [Select]
lo        no wireless extensions.

eth0      no wireless extensions.

eth1      IEEE 802.11abg  ESSID:"KISSHEART" 
          Mode:Managed  Frequency:2.437 GHz  Access Point: C0:C1:C0:2B:E4:89   
          Bit Rate=5.5 Mb/s   Tx-Power=200 dBm   
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:on
          Link Quality=26/70  Signal level=-84 dBm 
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

9
Hacking and Security / Re: Airmon-ng goes weird!
« on: September 02, 2014, 11:27:37 am »
yeah... i always logged in as root... and thanks for fast reply!

10
Hacking and Security / Airmon-ng goes weird!
« on: September 02, 2014, 11:11:15 am »
hey all of you awesome hackers. i just need your help for a bit. i installed airmon-ng package suit... for security reasons e.g exploiting own routers to detect some bugs. but. airmon-ng start to act weird...
Code: [Select]
Interface    Chipset        Driver

eth1        Broadcom    wl - [phy0]mon0: ERROR while getting interface flags: No such device

                (monitor mode enabled on mon0)
weird right? but i tried to reinstall the bcmw-kernel-source... and reinstall aircrack-ng package
nothing happens!

i hacked a lot of wifi using different techniques. but now i can't turn my wireless adapter into monitor mode. my perl programs are useless!

Pages: [1]