1
Beginner's Corner / Re: Help with Hydra
« on: March 09, 2015, 10:45:29 am »
Everything starts out ok but when the attack starts it says 0 tries per task. What I am doing wrong?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Beginner's Corner / Re: Help with Hydra
« on: March 08, 2015, 09:56:35 am »
I did try. Thank you very much for your help. I set the variable in the cmd in windows. When I started Hydra is says "Using connect Proxy" so I guess I did right. 
But I do have another question. In the Hydra Readme it says HYDRA_PROXY_HTTP is the variable for the http/www service and for all other services use HYDRA_PROXY to scan/crack. I was just curious as to the differences.
But I do have another question. In the Hydra Readme it says HYDRA_PROXY_HTTP is the variable for the http/www service and for all other services use HYDRA_PROXY to scan/crack. I was just curious as to the differences.
3
Beginner's Corner / Re: Help with Hydra
« on: March 08, 2015, 09:37:16 am »
so when I set the HYDRA_PROXY variable I then continue normally with Hydra? I just write the rest of the syntax?
4
Beginner's Corner / Re: Help with Hydra
« on: March 08, 2015, 09:24:23 am »
I have cygwin installed. How would I set the variable in cygwin?
5
Beginner's Corner / Re: Help with Hydra
« on: March 08, 2015, 09:02:42 am »
Thanks for the help. I'm afraid I'm still having trouble. I googled how to set shell variables but I don't understand how to do it. I found this command: set variable_name=value. Am I supposed to use that in the command line and then start Hydra? I'm using windows. Any help is appreciated.
6
Beginner's Corner / Help with Hydra
« on: March 07, 2015, 09:41:57 pm »
I've recently started using Hydra and I have learned a bit but I have one problem. How do I run Hydra with a proxy? I don't understand how to write it in the syntax. Thanks
Pages: [1]